🌐

Airless Spray Machine Large

📷
Images (6)

How To Use:

  • Filter Your Paint First With The Filter Bag That We Supply.
  • Place Siphon Tube Set Into Filtered Paint. Turn Power Off
  • Turn Pressure To Lowest Setting. Trigger Spray Gun To Relieve Pressure.
  • Turn Prime Valve Down (To Open Position).Turn Power On
  • Turn Pressure To Middle Position And Wait For Machine To Prime - Recirculating Into Your Paint Drum.
  • Turn Pressure To Lowest Setting. Turn Prime Valve Up (To Closed Position).
  • Trigger The Gun And Turn Pressure Up Only Until A Fine Spray Mist Is Obtained And The Apply To The Surface.
  • Never Use Old Paint Or Paint With Particulates In It.
  • The Machine Must Be Cleaned Immediately After Use.
  • Clean Machine After Use, Cleaning Fee R2000 If Returned Dirty. No Exceptions And No Arguments Please.
 

How To Clean:

  • Turn Power Off. Cleaning Your Airless Paint Sprayer Immediately After Every Use Pressure To Lowest Setting.
  • Trigger Spray Gun To Relieve Pressure. Turn Prime Valve Down (To Open Position).
  • Remove Guard And Tip. Clean Filter, Guard And Switch Tip In Flushing Fluid (Water, Paint Thinner Etc.).
  • Remove Siphon Tube Set From Paint And Place In Flushing Fluid.
  • Use Water For Water Base Paint And Mineral Spirits For Oil Base Paint.
  • If Sprayer Has A Filter, Unscrew Bowl, Remove Filter Assembly. Assemble Bowl Without Filter. Clean Filter. (not necessary with our machines)
  • Turn Power On And Prime Valve Horizontal (To Closed Position).Hold Spray Gun Against Paint Pail.
  • Trigger Gun And Increase Pressure Until Flushing Fluid Appears.
  • Move Airless Gun To Flushing Pail. Hold Spray Gun Against Pail And Trigger Gun To Thoroughly Flush System (Until Flushing Fluid Runs Clear).
  • Turn Prime Valve Down (Open Position) And Allow Flushing Fluid To Circulate For 1 To 2 Minutes To Clean Drain Tube.
  • Raise Siphon Tube Above Flushing Fluid And Run Sprayer For 15 To 30 Seconds To Drain Fluid. Turn Power Off.
  • Note: If Flushing With Water, Flush Again With Mineral Spirits Or Pump Armor (or sunlight liquid), This Leaves A Protective Coating In The System To Help Prevent Corrosion.
  • Install Filter Bowl And Filter Assembly. Hand Tighten Filter Bowl.
  • Wipe Sprayer, Hose And Spray Gun With A Rag Soaked In Water Or Mineral Spirits. MAKE SURE THE OUTSIDE OF THE MACHINE IS CLEAN
  • Never Use Old Paint Or Paint With Particulates In It.
  • The Machine Must Be Cleaned Immediately After Use.
  • Clean Machine After Use, Cleaning Fee R2000 If Returned Dirty. No Exceptions And No Arguments Please.
 
Made with 👉
LogoEmbed Notion